Skateboard bearings are one of the most important parts of a skateboard, and they need to be properly maintained in order to keep the board running smoothly. Sometimes you need to remove the skateboard wheel bearing so this article will going to help you and will elaborate on how to remove bearing from skateboard wheel.
How to Remove Bearing from Skateboard Wheel
The bearings are the point of contact between the skateboard deck and the wheels and they are what allow the board to roll. The bearings also have a small metal ball that acts as a bushing that helps the wheels roll easier.
Over time, dirt can get inside the bearing and cause it not to be able to roll because of all the dirt that has gotten inside. This article will tell you how to remove the bearing from the skateboard wheel.
Things You Need
To remove a skateboard bearing, you will need one bearing for each wheel (4 total).Â
You will need the skate tool, wrenches, or a set of screwdrivers to take the bearing out of the skateboard wheel.
The Process of How to Remove a Skateboard Bearing
First, you'll need to remove the axle nut using a wrench. Once the nut is loose, you can pull the axle out of the wheel.
Next, use a hammer to lightly tap the bearing out of the wheel. You may need to use a screwdriver to pry the bearing out if it's stuck.
Finally, clean the bearing seats with a cloth before putting new bearings in.
Â
With these tips, you'll have your bearings in no time!
How to Clean a Skateboard Bearing
Once you have removed all four of your skateboard bearings, take some time to clean them thoroughly. This can be done with soap and water, or diluted vinegar if they are particularly dirty. Be sure to dry them completely before attempting to put them back on your wheels.Â
Once they are clean and dry, simply reverse the process of removal to put them back in place! With fresh bearings in your wheels, you'll be skating smoothly in no time at all!
Why Do You Need to Clean, Fix, Or Replace the skateboard Bearings?
There are several reasons why we need to clean or replace the skateboard bearings.
One reason you might need to clean your skateboard bearings is if they start making noise. If your bearings start squeaking, it’s a good indication that they need to be cleaned.Â
Dirt and grime can build up on the bearing over time, causing it to make noise when you ride. Bearing noise can also be caused by dryness, so if your paths haven’t been lubricated in a while, this could be the problem.
Another reason you might need to fix or replace your skateboard bearings is if they start feeling sloppy. This usually happens when dirt and grime get into the bearing and start to cause friction. This can make riding your skateboard more difficult and damage the bearing itself. If you notice that your bearings feel loose or sloppy, it’s best to take care of them right away before they cause further damage.
Finally, if you simply want to upgrade your skateboard setup, replacing old bearings with new ones is always an option. Skateboards generally come with lower-quality bearings that are fine for beginner riders but may not last as long as higher-quality aftermarket options. If you’re looking for better performance from your skating setup, upgrade the bearing.
Conclusions
Bearing removal can be a tricky process, but with the right tools and a little patience, it can be done. This article provided a step-by-step guide on how to remove bearings from skateboard wheels. If you have any tips or tricks on bearing removal, be sure to share them in the comments below.
